Cobwebs are actually small feats
of engineering. Polymer scientists at the University of Akron have discovered
that the common house spider can tailor the type of adhesive discs it
uses to anchor its webs, making them stronger or weaker depending on
where the cobwebs are situated and the anticipated movements of its
prey.
Webs located up in the air, such as those on ceilings and vertical
surfaces, tend to catch flying insects, which are moving at a greater
velocity. So the adhesive used in these is stronger – that way the web
doesn’t come loose when it’s struck by an airborne object moving at a
high rate of speed. But when spiders build webs that are located close
to the ground, they use less adhesive in the discs. When an
unsuspecting insect wanders into a web, the anchoring thread snaps away
from the ground and – voila! – the spider’s dinner is left dangling
helplessly in the air by a sticky silk strand.
The polymer experts were impressed by the sophistication of this
trick. “What we have also discovered is a key design principle,” said
Ph.D graduate Vasav Sahni. “It’s not a question of the inherent
chemistry of the glue, but how the same glue can have different degrees
of adhesion.”
The Akron team have published the details of their study in the most recent issue of Nature Communications.
The discovery of 33 new species of sneaky trapdoor spiders boosts the
total number described in one genus from seven species to 40.
Trapdoor spiders, which belong to the same suborder as tarantulas,
are pretty badass. Instead of weaving webs, they build subterranean
silk-lined burrows — and cap the burrow with a trapdoor. Then, hunkered
down beneath the trap door, the spiders wait for an unsuspecting insect
to trigger the trip lines.
“They’re sort of ambush predators,” said arachnologist Jason Bond, director of the Auburn University Museum of Natural History, and author of the study describing the new species, which appeared Dec. 19 in the journal ZooKeys.
“They wait at burrow entrances at night, until some dull-witted insect
comes over. Then they jump out, bite it, and take it to their burrow.
This particular group, they pack its carcass down into the bottom of the
burrow.”
Some of the newcomers have pretty fantastic names. Aptostichus barackobamai is named for Barack Obama. Aptostichus bonoi, which lives in Joshua Tree National Park, is named after U2 band member Bono. Aptostichus sarlacc? That’s basically the Tatooine spider. It lives in the Southern California desert, and takes its name from Boba Fett’s ground-dwelling tormentor. The Atomic Penn Jillette Trapdoor spider (Aptostichus pennjillettei) is from the old nuclear testing site near Mercury, Nevada.
|
Male Aptostichus barackobamai. Image: Jason Bond. |
|
Female Aptostichus barackobamai. Image: Jason Bond. |
|
Female Aptostichus aguacaliente. Image: Jason Bond. |
|
Female Aptostichus atomarius. Image: Jason Bond. |
|
Female Aptostichus chavezi. Image: Jason Bond. |
|
Male Aptostichus miwok. Image: Jason Bond. |
|
Female Aptostichus stephencolberti. Image: Jason Bond. |
|
Trapdoor spider burrow, closed. Image: Jason Bond. |
|
Trapdoor spider burrow, open. Image: Jason Bond. |
One of the species in this newest batch, found near a relatively young,
volcanic cinder cone close to Barstow, CA, is named after Bond’s
daughter, Elisabeth. Living among the lava tubes that extend from the
cone, Aptostichus elisabethae builds deep, elaborate burrows
that extend multiple feet into the ground. Some of the other species
burrow only a few centimeters beneath the surface. “I’ve always
appreciated their engineering marvels,” Bond said, noting that the
spiders continually reinforce their burrow walls with silk, and that
some desert species maintain a routine of “winter cleaning,” leaving
little piles of excavated material outside.
No comments:
Post a Comment